This is to preorder the new mintyPi v3.5 which will run from September 30 until Mid October and once Preorders have closed the order will be sent to the PCB Factory . I am expecting at least 4-5 weeks to have everything back to me and then after packing orders will start to ship, so mid November they will go out.
Check your PayPal shipping addresses BEFORE you order a kit, please check your shipping info is updated and correct to avoid headaches on both sides
NOTE: mintyPi Logo is no longer present on the bootup as is shown in video above.
The kit includes the following ONLY! (if it’s not on this list it’s NOT INCLUDED) :
- Controller PCB w/ L&R Board
- FPC Ribbon (to connect LCD board to the Controller PCB)
- LCD PCB with the 2.6inch LCD
- Power Board with Battery Connector and L/R board solder points
- Headphone Socket
- Wiring Harness (connects Power Board & L/R board to Controller PCB)
There is the optional battery for the build which for the time being will be sold to Mexico, Canada and USA customers only. There reason for this is the extra customs paper work and cost in shipping them out (I didn’t make the laws but must abide by them).
Not Included are the 3D parts or the Custom Silicone buttons specifically made for the mintyPi V3.5. These can be bought from Wermy from Sudomod below):
DISCLAIMER!!: Since this is a DIY project with a lot of soldering involved I am not responsible for repairing or replacing parts you damage in the attempt of soldering the Pi to the PCBs I am offering in this kit. If it’s not pictured here then it is not included.
Please consider getting the mintyPi Practice Boards before attempting this project so there will no damaged boards in your assembly as I will not have extras to replace them. These will be available soon before preorders arrive.
Finished V3.5 Images: